HP 5130-24G-PoE+-4SFP+ (370W) EI Switch HP RENEW JG936A

Záruka na dobu životnosti (99 let) + NBD po celou dobu životnosti + 3-letá 24x7 Softwarová podpora v ceně
Rozsáhlá síť servisních středisek HP v ČR a na Slovensku

JG936AR

Před objednáním si vždy vyžádejte dostupnost (Pokud nejsou skladem u ATC). Podmínky na remarket trhu se mění velmi rychle. Pokud zboží není skladem, negarantujeme dostupnost ani cenu.

- Management: Fully Managed
- Layer 3 Dynamic: L2 switching / L3 Static routing / RIP routing
- 24x 10/100/1000 RJ45 portů + 4x 1000/10000 SFP+ porty
- Budget: 370W PoE+, (IEEE 802.3at)
- IRF stacking (až 9 switchů do stohu)
- Montáž do 19“ racku. Úchytky jsou součástí balení.

24 RJ-45 autosensing 10/100/1000 ports (IEEE 802.3 Type 10BASE-T, IEEE 802.3u Type 100BASE-TX, IEEE 802.3ab Type 1000BASE-T); Duplex: 10BASE-T/100BASE-TX: half or full; 1000BASE-T: full only
4 SFP+ fixed 1000/10000 SFP+ ports

1 RJ-45 serial console port

Dimensions
17.32(w) x 11.81(d) x 1.72(h) in (44 x 30 x 4.37 cm) (1U height)
Weight
17.64 lb (8 kg)

1 GB SDRAM, 128 MB flash; packet buffer size: 1.5 MB

Mounts in an EIA standard 19-inch telco rack or equipment cabinet (hardware included)

1000 Mb Latency < 5 µs
10 Gbps Latency < 1.5 µs
Throughput 96 Mpps
Routing/Switching capacity 128 Gbps
Routing table size 512 entries (IPv4), 256 entries (IPv6)
MAC address table size 16384 entries

MTBF (years) 48.3

Operating temperature 32°F to 113°F (0°C to 45°C)
Operating relative humidity 10% to 90%, noncondensing
Nonoperating/Storage temperature -40°F to 158°F (-40°C to 70°C)
Nonoperating/Storage relative humidity 5% to 95%, noncondensing
Acoustic Low-speed fan: 49.8 dB, High-speed fan: 52.9 dB; ISO 7779

Frequency 50/60 Hz
Maximum heat dissipation 102/1569 BTU/hr (107.61/1655.29 kJ/hr), for AC Power. For DC Power min heat dissipation is 85BTU/hr and max heat dissipation is 2559 BTU/hr
AC voltage 100 - 240 VAC
Current 10 A
Maximum power rating 460 W
Idle power N/A
PoE power 370 W PoE+

Maximum power rating and maximum heat dissipation are the worst-case theoretical maximum numbers provided for planning the infrastructure with fully loaded PoE (if equipped), 100% traffic, all ports plugged in, and all modules populated. PoE Power is the power supplied by the internal power supply. When supplemented with the use of an HP RPS1600 Redundant Power System, up to 740 W of PoE+ can be supplied.
Max current rating for DC power is 25A. AC Input power is 30W typical, and 460W max(including 370W PoE+ consumption. DC Input voltage range is -54 to -57VDC. Total DC input power is 25W Typical and 790W with 740W PoE+ Power consumption. DC Input voltage range is -54VDC to -57VDC. DC Input Source is the HP RPS1600.
Safety
UL 60950-1; EN 60825-1 Safety of Laser Products-Part 1; EN 60825-2 Safety of Laser Products-Part 2; IEC 60950-1; CAN/CSA-C22.2 No. 60950-1; Anatel; ULAR; GOST; EN 60950-1/A11; FDA 21 CFR Subchapter J; NOM; ROHS Compliance

EMC Directive 2004/108/EC; FCC (CFR 47, Part 15) Class A; EN 61000-4-11:2004; ANSI C63.4-2009; EN 61000-3-3:2008; VCCI V-4/2012.04; EN 6100-3-2:2006+A1:2009 + A2:2009; EN 61000-3-2:2006+A1:2009+A2:2009 ; EN 61000-4-3:2006; EN 61000-4-4:2012; EN 61000-4-5:2006; EN 61000-4-6:2009; AS/NZS CISPR 22:2009 Class A; CISPR 22:2008 Class A; EN 55022:2010 Class A; EN 61000-4-29: 2000; CISPR 24:2010; EN 300 386 V1.6.1; VCCI V-3/2013.04 Class A

Generic EN 55024
ESD EN300 386

IMC - Intelligent Management Center; command-line interface; Web browser; SNMP Manager

Refer to the HP website at: www.hp.com/networking/services for details on the service-level descriptions and product numbers. For details about services and response times in your area, please contact your local HP sales office.